User's Manual
Table Of Contents
- Preface
- 1 NCL1135 Overview
- 2 Network Considerations
- 3 Configuring the NCL1135
- 4 Testing
- 5 Deploying the NCL1135
- 6 Operational Statistics
- 7 Troubleshooting
- Appendix A NCL1135 CommandLine Syntax
- Appendix B Abbreviations and Terminology
- Appendix C Operating Channel Frequencies
- Appendix D NCL1135 Specifications
- Appendix E Configuration Data Record
Chapter 3 Configuring the NCL1135
APCD–NC003–1.0 31
3.4.2 Establishing a Telnet Session
Use a Telnet connection to the NCL1135 to modify configuration parameters or to restart the
NCL1135 from a remote location.
You can use a standard Telnet application to connect to the NCL1135.
1. Start the Telnet application on your computer.
2. Use a remote system connection to connect to the IP address for the NCL1135.
3. At the Password prompt, type the NCL1135 password. The application opens a
terminal-emulation screen.
4. Modify the configuration parameters as necessary.
5. When done, type <exit> to close the Telnet session.
NOTE: If you perform a restart or reboot from a Telnet connection, the
NCL1135 will drop your connection. You will need to reconnect to
the NCL1135 after a restart.
3.4.3 Establishing a Web Browser Connection
You can remotely connect to an NCL1135 through an Internet web browser, such as MS
Internet Explorer or Netscape, to update the configuration. When you access the NCL1135
using your browser, you can modify the configuration parameters displayed on the
configuration pages.
NOTE: The browsing support feature only allows you to update the
configuration. You cannot remotely configure a factory-configured
NCL1135 until after you configure the IP address for the device.
The following procedure describes how to access the NCL1135 via the Internet.
1. Open the web browser that you have installed on your computer.
2. In the web browser URL field, type:
<http://
NCL1135_ip_address/
>
3. Press ENTER. The WaveRider NCL1135 Configuration page appears.
4. Click one of the links to open a configuration page. A dialog box prompts you for the
User Name and Password for the NCL1135.
NOTE: Refer to the Configuration Data Record for the NCL1135. Both
the User Name and Password are case-sensitive.
5. Type <NCL1135> in the User Name field.
6. Type the NCL1135 password in the Password field.
7. Press ENTER. The Configuration page is displayed.
8. Follow the instructions on the screens to modify the NCL1135 configuration.