User's Manual
Table Of Contents
- Preface
- 1 NCL1135 Overview
- 2 Network Considerations
- 3 Configuring the NCL1135
- 4 Testing
- 5 Deploying the NCL1135
- 6 Operational Statistics
- 7 Troubleshooting
- Appendix A NCL1135 CommandLine Syntax
- Appendix B Abbreviations and Terminology
- Appendix C Operating Channel Frequencies
- Appendix D NCL1135 Specifications
- Appendix E Configuration Data Record
Chapter 3 Configuring the NCL1135
16 APCD–NC003–1.0
3.2 Configuring the NCL1135
The procedures to configure the NCL1135 using a command-line interface are broken into two
main sections:
• Radio configuration — see
Setting the Radio Configuration
on page 16
• IP configuration — see
Setting the IP Configuration
on page 18
To configure an NCL1135 correctly, you must complete both the radio and IP configuration
procedures.
You can also configure the NCL1135 with the following functionality:
• DHCP Relay — see
Setting the DHCP Relay Configuration
on page 19
• SNMP — see
Setting the SNMP Configuration
on page 20
• DNS Resolver — see
Setting the DNS Resolver Configuration
on page 21
3.2.1 Setting the Radio Configuration
Before setting the radio configuration parameters, ensure that the NCL1135 has been
connected to a terminal and initialized as described in
Connecting and Initializing the
NCL1135
, on page 12 and you have changed the password as described in
Changing the
NCL1135 Password
, on page 14.
WARNING!
Antennas and associated transmission cable must be installed
by qualified personnel. Failure to terminate the antenna port
correctly can permanently damage the NCL1135. WaveRider
assumes no liability for failure to adhere to this recommendation
or to recognized general safety precautions.
1. Determine the radio channel for the network. See Appendix C for a list of operating
frequencies.
2. At the NCL1135> prompt, type <radio channel
channel
> to set the radio
channel for the NCL1135 where
channel
is the number of the network radio channel
on which it will be operating.
3. Determine the unit IDs for the Master and Stations for this NCL1135 network group.
The unit ID is a unique number, from 1 to 16383, that is used to identify the NCL1135
within the network group.
4. At the NCL1135> prompt, type <radio unitid
unit_id
> to set the NCL1135 unit
ID.
5. Set the NCL1135 as a Master or Station. To set the NCL1135 as a Master, type
<radio type master>. To set the NCL1135 as a Station, type <radio type
station>.