User's Manual

Chapter 3 Configuring the NCL1135
14 APCD–NC003–1.0
3.1.1 Changing the NCL1135 Password
You must be successfully connected and logged into the NCL1135.
For security, we recommend that you set the password for each unit in your network to a
unique password and that you record the password on the Configuration Data Record for the
group. Refer to Appendix E for a copy of the NCL1135 Network Group Configuration Data
Record.
1. At the NCL1135> prompt, type <system password>.
2. At the Enter Current Password: prompt, type the old password.
3. At the Enter New Password: prompt, type the new password.
TIP: Use a maximum of sixteen (16) alphanumeric,
ASCII characters. Passwords are case-sensitive. For
example, “abc” is not the same as “aBc”.
4. At the Verify password: prompt, type the new password again.
5. The system will display a message that your password has been successfully
changed. Your session to change the password may be similar to the following
example session:
NCL1135> system password
Enter Current Password: *******
Enter New Password: ****
Verify password: ****
System password has been changed.
NCL1135>
6. Type <write> or <save> to save the settings to memory.
CAUTION: Remember to record the password in your Data Configuration Record.
Unlocking the NCL1135 can be a complicated process. If you have forgotten the
password, contact the WaveRider Customer Support Centre for assistance.