User's Manual
Table Of Contents
- Preface
- 1 NCL1135 Overview
- 2 Network Considerations
- 3 Configuring the NCL1135
- 4 Testing
- 5 Deploying the NCL1135
- 6 Operational Statistics
- 7 Troubleshooting
- Appendix A NCL1135 CommandLine Syntax
- Appendix B Abbreviations and Terminology
- Appendix C Operating Channel Frequencies
- Appendix D NCL1135 Specifications
- Appendix E Configuration Data Record
Chapter 3 Configuring the NCL1135
12 APCD–NC003–1.0
3.1 Connecting and Initializing the NCL1135
WARNING!
Antennas and associated transmission cable must be installed
by qualified personnel. Failure to terminate the antenna port
correctly can permanently damage the NCL1135. WaveRider
assumes no liability for failure to adhere to this recommendation
or to recognized general safety precautions.
1. Attach the antenna or a 50-ohm load to the antenna connection on the back of the
NCL1135. Do NOT plug the NCL1135 to the power outlet until you have the antenna
or load connected.
NOTE: The NCL1135 is factory preset with the radio transmission
capabilities disabled to prevent equipment damage. However, as
a general precaution, WaveRider recommends that you always
connect the antenna or load before
connecting to a power
source.
Figure 8 NCL1135 Connections
2. Use an RS-232 crossover cable to connect a terminal to the DB9 port.
Ethernet
Link LED
10BaseTx Ethernet
Connector (RJ-45)
Power
Supply
RS-232 Connector
(DB9 consoleport)
Antenna Connector
(Reverse-Polarity SMA)
Power LED