User Manual

62 APCD–NC003–2.0A
mode Displays the forwarding mode: Bridging or IP Routing.
mode bridging|routing Changes the forwarding mode.
bridging: connects two networks on the same subnet
(they have the same subnet address).
routing: connects two networks on different subnets.
radio Displays the radio configuration information.
radio channel Displays the radio channel.
radio channel (1–14) Changes the radio channel.
radio disable|enable Disables or enables the NCL1135 radio transmission
capabilities. The NCL1135 is factory-configured as
disabled to prevent accidental damage should it be
powered up without an antenna or load connected.
radio per
[single|continuous|reset]
Displays or resets the cumulative radio packet error rate
statistics to the screen. This command is available
during tests and normal operation.
• single displays the current statistics.
• continuous displays the statistics every one
second.
• reset resets the calculations.
radio rxtest start|stop Starts and stops the Radio Continuous Receive Test.
When you start this test, the Radio PER display is also
automatically started. Available only at the Station
NCL1135. Use this test to deploy a new Station
NCL1135 in an existing network.
radio txtest start|stop Starts and stops the Radio Continuous Transmit Test.
Available only at the Master NCL1135. Use this test to
set up a Master and Station for a new network.
radio txrx start|stop Starts and stops the Radio Transmit/Receive Loopback
Test. When you start this test, the Radio PER display is
also automatically started. Available only at the Master
NCL1135. Use this test for a new installation only.
radio reset Forces the NCL1135 to reset. If you reset the NCL1135
radio instead of shutting down, the statistics are not lost.
If you use this command, the link service is disrupted for
the duration of the test.
radio unitid Displays the NCL1135 unit ID.
radio unitid (1–16383) Changes the NCL1135 unit ID. An NCL1135 unit ID is a
unique number between 1 and 16383.
radio masterID Displays the Master Unit ID to which the NCL1135
belongs. Available only if the NCL1135 radio type is
Station.
radio masterID (1–16383) Changes the Master Unit ID to which the NCL1135
belongs. Available only if the NCL1135 radio type is
Station.
Command Syntax Description