User Manual

3 Configuring the NCL1135
APCD–NC003–2.0A 33
3.4.2 Establishing a Telnet Session
Use a Telnet connection to the NCL1135 to modify configuration parameters or to restart the
NCL1135 from a remote location.
CAUTION: If you connect to the NCL1135 using Telnet and change the radio or
Ethernet IP address, your connection to the device will be dropped. You will need to
reconnect to the NCL1135 using the new IP address in order to save your changes
to the device. When you use a local serial connection, this does not occur.
You can use a standard Telnet application to connect to the NCL1135.
1. Start the Telnet application on your computer.
2. Use a remote system connection to connect to the IP address for the NCL1135.
3. At the Password prompt, type the NCL1135 password. The application opens a
terminal-emulation screen.
4. Modify the configuration parameters as necessary.
5. When done, type <exit> to close the Telnet session.
NOTE: If you perform a restart or reboot from a Telnet connection, the
NCL1135 will drop your connection. You will need to reconnect to
the NCL1135 after a restart.