User Manual

3 Configuring the NCL1135
16 APCD–NC003–2.0A
3.2 Configuring the NCL1135
The procedures to configure the NCL1135 using a command-line interface are divided into two
main sections:
• Radio configuration — see Setting the Radio Configuration on page 16
• IP configuration — see Setting the IP Configuration on page 18
You can also configure the NCL1135 with the following options:
• Routing Information Protocol (RIP)—see Setting RIP Configuration on page 19
• Open Shortest Path First (OSPF)—see Setting OSPF Configuration on page 20
• Dynamic Host Control Protocol (DHCP) Relay—see Setting the DHCP Relay
Configuration on page 21
• Simple Network Management Protocol (SNMP)—see Setting the SNMP Configuration
on page 22
• Domain Name Server (DNS) Resolver—see Setting the DNS Resolver Configuration
on page 23
3.2.1 Setting the Radio Configuration
Before setting the radio configuration parameters, ensure that the NCL1135 has been
connected to a terminal and initialized as described in Connecting and Initializing the
NCL1135, on page 12 and you have changed the password as described in Changing the
NCL1135 Password, on page 14.
WARNING!
Antennas and associated transmission cable must be installed
by qualified personnel. Failure to terminate the antenna port
correctly can permanently damage the NCL1135. WaveRider
assumes no liability for failure to adhere to this recommendation
or to recognized general safety precautions.
1. Determine the radio channel for the network. See Appendix C for a list of operating
frequencies.
2. At the NCL1135> prompt, type <radio channel channel> to set the radio
channel for the NCL1135 where channel is the number of the network radio channel
on which it will be operating.
3. Determine the unit IDs for the Master and Stations for this NCL1135 network group.
The unit ID is a unique number, from 1 to 16383, that is used to identify the NCL1135
within the network group.
4. At the NCL1135> prompt, type <radio unitid unit_id> to set the NCL1135 unit
ID.