User's Manual

obr5000b_ml_r01_sdApproved: D.W.
3-2
3.2 Overview of Configuration
The following steps outline the process for configuring a VistaMAX system operating at 5000 MHz. This process
assumes that you are using an NMS8000.
Step 1 Use CAT5 straight-through Ethernet cables to connect the physical components as shown in Figure 3-1,
on page 3-1.
Step 2 Use the Web-based interface to configure the IP addresses for the base station and subscriber station(s).
If necessary, configure the IP addresses for the NMS8000.
Step 3 Use the Web-based interface to configure the radio parameters for the base station and subscriber
station(s).
Step 4 If necessary, use the Web-based interface for the NMS8000 to add the subscriber stations on the
NMS8000.
Step 5 Establish the link between the base stations and subscriber stations and verify that the subscriber stations
are online.
The steps that pertain to the base station are described in more detail below. For more information, refer to the NMS8000
& NMS8000/SSP Network Management Server Installation and Operation Guide or related information listed
under Finding Related Documentation, on page iv.
3.3 Using the Web Based Interface
The Web interface of the OBR5000B system may be viewed with a standard web browser such as Mozilla™ or Internet
Explorer™, no additional add-ins are required.
NOTE
If your Web certificate is invalid or expired, you might need to add an exemption to the certificate or upgrade
your Java Runtime Environment (JRE) software.
The following are the default log on settings for the Base station Web-based interface:
• Web-based interface access — https://192.168.101.2
• subnetwork mask — 255.255.255.0
•username — root
• password — vistamax