User's Manual

obr5000b_ml_r01_sd Approved: D.W.
3-5
To change the base station IP address:
Step 1 Log on to the Web-based interface and click Configuration > Network Configuration. The Current
Interfaces table displays showing the primary (br0) IP address and virtual addresses (br0:1 br0:2, etc) for
your base station.
Step 2
Parameter Description Default
From this page, you can set the following parameters:
Click the br0 link under Name field in the Current Interfaces table. The window will change to this.
• In the Primary IP Address field, enter the new IP for the Base Station: 192.168.101.138
• In the Primary IP Subnet Mask field, enter the subnet mask for the Base Station. 255.255.255.0
• In the Primary IP Gateway field, enter the gateway address for your network 192.168.101.3
Step 3 Click the Submit button. The following message appears:
Step 4 Click the here link to make the change permanent.
NOTE
At this point, you may need to change the IP configuration of the computer which you are using to
access the base station.If you have completely changed the domain for the Base Station (was
192.168.101.1, now 172.200.26.1), please ensure the IP of the computer is capable of
communicating with the new IP address of the BS. If not, adjust the network configuration of the
computer accordingly before moving on to the next step.
br0 and Virtual
Interfaces
This is where the primary interface (br0) and any
virtual interfaces (br0:1, br0:2, etc.) will be
configured for remote access.
The primary interface is the IP address for the Base
Station.
Dependent on your
network design.
Gateway This is where the default gateway will be specified
for the br0.
Dependent on your
network design.