User's Manual

obr3650hp_ml_r01_sdApproved: D.W.
2-6
2.2.1 Water Proof the Connection
Wrapping the antenna connection with sealing tape keeps the connection tight and protects against moisture.
To water proof the connection follow these steps:
Step 1 Use a section of rubber sealing tape. Starting at the OBR3650HP end, stretch the tape and wrap it around
the connector as close as possible to the body of the OBR3650HP. Overlap the tape by approximately one-
half of its width so that it can form a seal with itself. Extend the wrapping to approximately one-inch past the
end of the connector.
Figure 2-6 Apply Rubber Sealing Tape
Step 2 Cover the sealing tape with electrical tape. Start approximately one inch further down the cable, and stretch
the tape, overlapping by one-half. Wrap to the OBR3650HP end, then without breaking the tape, wrap back
down to the cable end.
Figure 2-7 Water Proofed Connection