User's Manual

obr3650hp_ml_r01_sd Approved: D.W.
3-5
To change the base station IP address:
Step 1 Log on to the Web-based interface and click Configuration > Network Configuration. The Current
Interfaces table displays showing the primary (br0) IP address and virtual addresses (br0:1 br0:2, etc) for
your base station.
From this page, you can set the following parameters:
Step 2 Click the br0 link under Name field in the Current Interfaces table. The window will change to this.
•In the Primary IP Address field, enter the new IP for the Base Station: 192.168.101.138
•In the Primary IP Subnet Mask field, enter the subnet mask for the Base Station. 255.255.255.0
•In the Primary IP Gateway field, enter the gateway address for your network 192.168.101.3
Parameter Description Default
br0 and Virtual
Interfaces
This is where the primary interface (br0) and any
virtual interfaces (br0:1, br0:2, etc.) will be
configured for remote access.
The primary interface is the IP address for the Base
Station.
Dependent on your
network design.
Gateway This is where the default gateway will be specified
for the br0.
Dependent on your
network design.