Installation Instructions

obr3650hp_ml_r01_sd Approved: C.W.
A-5
Figure A-7 Cable ready for crimping
Step 4 Before installing into the connector bend back the metal strain relief along the cable length. The metal strain
relief should fit just after the jacket and cover the foil.
Check the following before crimping:
1) The wires are in the correct order. See Figure A-6
2) You can see the copper ends of the wires. If the wires are not snug against the connector end, the
connection will be intermittent.
After ensuring that the cable is prepared correctly, crimp the cable using a WT1144 or WT1145 crimping
tool as shown in Figure A-8. The crimped cable is shown in Figure A-9.
NOTE
If no crimping tool is available, use a pair of pliers to crimp the shield to the cable.
Ensure that the shield is securely attached to the cable.
Figure A-8 Crimping the cable
Figure A-9 Assembled cable terminating end