Installation Instructions

obr3650hp_ml_r01_sdApproved: C.W.
3-4
To configure a network using NMS8000:
Step 1 Open the base station graphical user interface (GUI) and click Configuration > Network Configuration.
The Current Interfaces screen opens displaying the name, IP address, and netmask of the base station’s
primary interface. The default value is 192.168.101.2. To modify this value, click br0 to open the BR0
configuration screen and type the new value in the appropriate field. See “To change the base station IP
address“ below for a detailed description of this Step.
Step 2 Using the NMS GUI, set up and enable DHCP on the NMS, then configure the subscriber stations and host
computers as required.
NOTE
For more information see the NMS8000 & NMS8000/SSP Network Management Server Installation and
Operation Guide.
To change the base station IP address:
Step 1 Log on to the Web-based interface and click Configuration > Network Configuration. The Current
Interfaces table displays showing the primary (br0) IP address and virtual addresses (br0:1 br0:2, etc.) for
your base station.
From this page, you can set the following parameters:
Parameter Description Default
br0 and Virtual
Interfaces
This is where the primary interface (br0) and any
virtual interfaces (br0:1, br0:2, etc.) will be
configured for remote access.
The primary interface is the IP address for the Base
Station.
Dependent on your
network design.
Gateway This is where the default gateway will be specified
for the br0.
Dependent on your
network design.