Installation Instructions

obr3650hp_ml_r01_sd Approved: C.W.
3-3
NOTE
192.168.101.2 is the default IP address that comes preconfigured from Vecima, but your IP address
might be different. If you are not using the default address, contact your system administrator for the IP
address.
Step 2 Type the username root and the password vistamax to access the web GUI. The log on screen displays:
3.4 Configuring the Network
You will need to configure your network to establish communication between the network elements. Figure 3-2 shows
an example of a properly configured network. The example shows a network configuration using default values. If you
purchased a WiMAX starter kit, these value will already be set.
The VistaMAX Base Station is shipped with a default IP address. However, depending upon your network configuration,
you may want to change the IP address of your Base Station.
Figure 3-2 Network Diagram
As per the WiMAX standard, the subscriber station requires an IP address and TFTP offered to it during network entry.
To fulfill this requirement, both a DHCP and TFTP server must be present. It is possible to use a third-party customer-
supplied DHCP and TFTP server, but Vecima recommends using the Network Management Server 8000 (NMS8000).
Most Vecima starter kits come with an NMS as part of the solution.
NOTE
Customers who purchased the basic starter kit or who do not have an NMS must use the WiMAX-out-of-the-box
(WOOTB) procedure. For more information about WOOTB, contact the Application Engineering Support at
Vecima Networks.