User's Manual Part 2

obr3650_ml_01_sdApproved: C.W.
3-2
3.2 Overview of Configuration
The following steps outline the process for configuring a VistaMAX system. This process assumes that you are using an
NMS8000.
Step 1 Use CAT5 straight-through Ethernet cables to connect the physical components as shown in Using
NMS8000 to Provision VistaMAX System.
Step 2 Use the Web-based interface to configure the IP addresses for the base station and subscriber station(s).
If necessary, configure the IP addresses for the NMS8000.
Step 3 Use the Web-based interface to configure the radio parameters for the base station and subscriber
station(s).
Step 4 If necessary, use the Web-based interface for the NMS8000 to add the subscriber stations on the
NMS8000.
Step 5 Establish the link between the base stations and subscriber stations and verify that the subscriber stations
are online.
The steps that pertain to the base station are described in more detail below. For more information, refer to the NMS8000
& NMS8000/SSP Network Management Server Installation and Operation Guide or related information listed
under Finding Related Documentation on page iii.