User's Manual Part 2

obr3650_ml_01_sdApproved: C.W.
3-18
To create service flows and associate them with service classes and classifier templates.
1) Click Configuration > Service Flows > Service Flows to open a page displaying the predefined service flows. Use
this page to provision subscriber stations with service flows according to their MAC addresses.
2) Click Add. A new page opens displaying the Add Service Flow table. Use this page to set up the service flow
parameters.
3) Type a number in the SFID field to identify the service flow.
4) Select UpStream or DownStream from the Direction drop list to indicate the direction of the data to which the
service flow will apply.
5) Select a specification from the Convergence SubLayer Specification drop list to indicate the protocol that the
service flow uses. The default is IPv4 over Ethernet.
6) Select the State of the service flow: Authorized, Admitted, or Active.
7) Select a service class to include with the service flow.
8) Select a classifier template to include with the service flow.
9) Click Add. This saves the service flow and returns you to the Service Flow Table page where the new service flow
is displayed. You can then use this service flow to provision subscriber stations.