Installation and Operation Manual

NCL1100 Installation & Operation Manual
1990/07/21 – 13 –
• † In a TCP/IP network, these are IP addresses of network management stations to which
to send traps (alerts) if an alarm occurs.
In an IPX network, these are IPX network addresses (e.g., smcDosWsTrapDstAdr.1) of
the network management stations where traps are sent. Traps can be sent to a
maximum of three management stations (Adr.1, Adr.2, and Adr.3).
• ‡ In an IPX network, if the network management station is on another network, the
protocol specified here must be acceptable to the router on the local network.
An example is smcDosWsTrapDstPro.1 = 2. The protocols include:
 1 = not used
 2 = TCP/IP (Ethernet and Token Ring)
 3 = IPX with Ethernet II frame type (Ethernet only)
 4 = IPX with 802.2 (LLC) frame type (Ethernet and Token Ring)
 5 = IPX with SNAP frame type (Ethernet and Token Ring)
 6 = IPX with 802.3 frame type (Ethernet only)