User's Manual

ma4367_ml_03_sd Approved: B.G. 34
Vecima Networks Inc.
6.5.2 MA4070C Power Amplifier Detailed Command Descriptions and System Responses
This section defines each of the command codes and the associated parameters for the MA4070C Power Amplifier module.
OE - Enable Output
Description: Turns on the Output from the specified module.
Parameters: None
Example: *999<sp>A<sp>OE<sp>CRC<cr>
Response: OK or MOD or ERR or CRC
OD - Disable Output
Description: Turns off the Output from the specified module.
Parameters: None
Example: *999<sp>A<sp>OD<sp>CRC<cr>
Response: OK or MOD or ERR or CRC
LE - Enable Local Control
Description: Enables local control of the MA4367 system. The module address must indicate a valid module even though the
command does not change any module settings.
Parameters: None
Example: *999<sp>A<sp>LE<sp>CRC<cr>
Response: OK or MOD or ERR or CRC
LD - Disable Local Control
Description: Disables local control of the MA4367 system. The module address must indicate a valid module even though the
command does not change any module settings.
Parameters: None
Example: *999<sp>A<sp>LD<sp>CRC<cr>
Response: OK or MOD or ERR or CRC
SU - Status Unit Request
Description: The Status Unit Request command returns the factory model and revision history for the specified module. The
detailed contents of the reply are shown in the response section.
Parameters: None
Example: *999<sp>A<sp>SU<sp>CRC<cr>
Response: OK or MOD or ERR or CRC
If the response is OK, then the following parameters will also be returned in the order shown below. (Note: X may be
replaced by any valid character. All other characters will be as shown).