User's Manual
ma4367_ml_03_sd Approved: B.G. 11
Vecima Networks Inc.
3.0 OPERATION
3.1 Front Panel Description
DIAGRAM 3.1A : FRONT PANEL â MA4367 SYSTEM
Vecima Networ ks
MA4009B
POWER ALARM MODULE
SELECT
AUX
SYSTEM 4000
POWER SUPPLY
MA4011B
DOWN UP
MODE
MODULE
SELECT
Vecima Networ ks
MA4009B
Vecima Networks
MA4009B
Vecima Networks
MA4009B
Vecima Networks
MA4009B
MA4070C MMDS
POWER AMPLIFIER
2.5-2.7 GHz
DC
POWER
RF HIGH
ALARM
RF LOW
ALARM
HIGH REV.
POWER
ALARM
UNIT
SELECT
POWER
MODULE
SELECT
ALARM
RF ENABLED
MA4061B
MMDS DIGITAL
UPCONV ERTER
As shown in Diagram 3.1A, the power/control module front panel has an LCD display, four soft touch push buttons, and 4
indicator LEDs. All other modules have 4 indicator LEDs. Modules are configured using push buttons on the power supply
module, or via the remote interface. If no configuration adjustments are being made via the front panel controls, the display
back light will shut off after a five minute interval. Pressing any of the front panel buttons will re-enable the back light.
3.1.1 MA4011B/MA4012B Power/Control Modules
D
IAGRAM 3.1B : FRONT PANEL â MA4367
POWER ALARM MODULE
SELECT
AUX
SYSTEM 4000
POWER SUPPLY
MA4011B
DOWN UP
MODE
MODULE
SELECT
DISPLAY
The first line on the display
is the Mode Information Line. It shows the settings for the currently selected module. The possible
operating modes depend upon the currently selected module (See Section 3.2, Front Panel Operating Modes for a detailed
description of the available modes).
The second line on the display
is the Status Information Line. The Status Line is divided as follows:
The two leftmost characters are âmXâ where X is replaced by the currently selected module address. When used with the
MA4070C Power Amp Module or the MA4070C Power Amp Module, they can be installed as shown in Diagram 3.1A.