Manualshelf

User's Manual

ManualsBrandsVecima Networks ManualsElectronicsMA4070B
31323334353637383940
WaveCom Electronics Inc
MA4061/MA4070 Manual; MAN1L2301 Rev03 (Mar 2002)
Approved: R. L.
40
FPLS – Set Forward Power Low
Description: Sets the Forward Power Low for the specified module. When the Forward Power Low is enabled, and
the RF Power is below the threshold limit, a non-critical alarm will be triggered.
Parameters: Desired RF Thresholds in dBm, in the form XX.X. The decimal point and trailing characters are
required. The trailing character can range between 0.0 and 0.9
Example: *999<sp>B<sp>FPLS<sp>34.0<sp>CRC<cr>
Response: OK or MOD or ERR or CRC
FPLE – Enable Forward Power Low
Description: Enables the Forward Power Low for the specified module. When the Forward Power Low is enabled,
and the RF Power is below the threshold limit, a non-critical alarm will be triggered.
Parameters: None
Example: *999<sp>B<sp>FLPE<sp>CRC<cr>
Response: OK or MOD or ERR or CRC
FPLD – Disable Forward Power Low
Description: Disables the Forward Power Low for the specified module.
Parameters: None
Example: *999<sp>B<sp>FPLD<sp>CRC<cr>
Response: OK or MOD or ERR or CRC
RPS – Set Reverse Power Threshold
Description: Sets the Reverse Power Threshold for the specified module. When the Reverse Power Threshold is
enabled, and the RF Power is above the threshold limit, a non-critical alarm will be triggered.
Parameters: Desired RF Thresholds in dBm, in the form XX.X. The decimal point and trailing characters are
required. The trailing character can range between 0.0 and 0.9
Example: *999<sp>B<sp>RPS<sp>25.0<sp>CRC<cr>
Response: OK or MOD or ERR or CRC
RPE – Enable Reverse Power Threshold
Description: Sets the Reverse Power Threshold for the specified module. When the Reverse Power Threshold is
enabled, and the RF Power is above the threshold limit, a non-critical alarm will be triggered.
Parameters: None
Example: *999<sp>B<sp>RPE<sp>CRC<cr>
Response: OK or MOD or ERR or CRC
RPD – Disable Reverse Power Threshold
Description: Disables the Reverse Power Threshold for the specified module.
Parameters: None
Example: *999<sp>B<sp>RPD<sp>CRC<cr>
Response: OK or MOD or ERR or CRC