User Manual

3: Installation
APCD-LM047-1.1 17
The easiest installation uses the EUM3005 factory defaults, so that the modem will gets all its
IP address information from DHCP and its RF Frequency from the Automatic CCU Discovery
feature.
Other useful information for the installer includes:
• Direction from the installation site to the CCU.
• Expected signal strength for the installation site based on the network operator’s site
survey or signal strength for other installations in the vicinity.
• The IP address of a site that accepts pings as well as the name of a site that accepts
pings, for testing the data link.
• Whether modem is being connected directly to end-user PC or via an Ethernet switch
or IP router. In the latter cases, the installer must provide a straight-through Ethernet
cable to connect the modem to the switch/router.
3.2.2 Verifying the EUM3005 Components
Verify that the EUM3005 kit is complete with:
• EUM3005 modem
• Indoor antenna with its captive 10 feet of RF cable.
• Antenna Mounting hardware, including drywall plugs, screws and suction cups
• AC/DC power supply (may include AC power cable)
• Crossover Ethernet cable.
3.2.3 End-Users PC
Ensure that the end-user PC is equipped with an Ethernet interface.
3.3 Installation Steps
NOTE: Turn off all cordless phones in the customer’s premises, and any
other equipment that uses the 900MHz ISM band. Once the
installation is complete, turn this equipment back on and monitor
for interference or degraded signal quality.