User Manual

6 APCD-LM047-1.1
1: Introduction
Figure 3 WaveRider Switched-beam Diversity Antenna — Beam Patterns
The end user must position the switched-beam diversity antenna correctly to receive an
adequate signal level. The Radio LED on the EUM3005, described in section 1.4, Indicators
and Connectors, can be used to help with the alignment. Since the switched-beam diversity
antenna has a good front-to-back ratio, it can be positioned to suppress interference from
other wireless devices at the end-user’s premises.
The EUM3005 is not approved to be used with any other antenna. For installations requiring
an outdoor antenna, the EUM3006 Integrated Outdoor Modem is recommended for its
superior performance and ease of installation.
The EUM3005 Active Diversity Indoor Antenna comes equipped with a 3 m RF cable and
connector. The connector is a proprietary WaveRider connector, which is mandated by the
FCC requirement that the connectors used in ISM band products that are not professionally
installed must be unique, or at least not readily available.
1.3.3 Ethernet Port
The EUM has one 10BaseT Ethernet port. Details on the Ethernet port are found in Appendix
B on page 27.
CAUTION: Any DC voltage applied to the Ethernet port may
damage the EUM, the Ethernet cable, and/or network gear. The
EUM3005 is not
a Power-over-Ethernet device.
1.3.4 Power Supply
Power is provided to EUM3005 through its AC/DC Power supply, which supplies 4.2 VDC
through a standard barrel (5.5 x 2.5 x 9.5 mm) connector to the modem.
CAUTION: Using any other power supply than that provided by
WaveRider, especially any other DC voltage will result in damage
to the modem.
Beam Pattern A
Beam Pattern B