User's Manual Part 2

Appendix E: Access Interface
APCD-LM043-8.0 (DRAFT C) 225
4. At the prompt, type bcf and press Enter.
WaveRider Communications, Inc. LMS3000
Password:
InOp> bcf
Basic Cfg File:
File ID : basic.cfg
File Time Stamp:
File Version : 5
File Notes : Operator updated
File CRC : 0xE1
IP Address: 192.168.10.250 / 24
IP Subnet : 192.168.10.0 ( 255.255.255.0 )
Gateway IP Address: 192.168.10.1
Contact: WaveRider Communications Inc.
Location: www.waverider.com
Name: LMS3000
SNMP Read Communities:
public
SNMP Write Communities:
private
SNMP Traps:
Statistics Log Interval: 15 minutes
Radio Frequency: 9050
RF Power: LOW
Maximum Number of Customers: 1
InOp>
5. Note the IP settings in the BCF.
6. Type
reset and press Enter.
The EUM3003 is now functioning with its previous IP configuration.
Using the INOP Button When You Cannot Connect to an EUM3003
The EUM3003 may come up in the INOP Mode if the startup fails due to a corrupt boot
sequence or other problem. INOP Mode resets the IP address to the default setting of
192.168.10.250 /24.
To Use the INOP Button
1. From a PC on the 192.168.10.0 /24 subnet, attempt to connect to the EUM3003
through a local Telnet connection.
2. If the connection is successful
a. At the prompt, type
ip and press Enter.
60:ff:fe> ip
Ethernet IP Address: 192.168.10.100
Ethernet Net Mask : ffffff00
Gateway IP Address: 192.168.10.1
60:ff:fe>
b. At the prompt, type file dir and press Enter.
60:ff:fe> file dir
Filename Size CRC