User's Manual Part 2

Appendix E: Access Interface

APCD-LM043-8.0 (DRAFT C) 223

3. At the prompt, type telnet aaa.bbb.ccc.ddd and press Enter. (aaa.bbb.ccc.ddd

is the IP Ethernet address of the CCU or EUM.)

WaveRider Communications, Inc. LMS3000

Password:

4. At the password prompt, type the device password and press Enter.

NOTE: The default password for CCUs and EUMs is carriage return.

60:ff:fe>

You are now connected to the CCU or EUM with a Telnet session, and you may issue

CLI commands to the device at the command prompt.

Serial Port Connection

To Connect to a CCU3000 or EUM3000 Through a Serial Port

1. Connect and RS-232, DB9 male to DB9 female, straight-through cable between the

console ports on the CCU3000 or EUM3000 and the PC.

2. Open a terminal emulation program, such as Tera Term Pro or HyperTerminal.

NOTE: You can download Tera Term Pro from WaveRider Technical

Support.

3. Connect to the device using the port settings shown in Table 45.

Table 45 Serial Port Settings

4. At the password prompt, type the device password and press Enter.

NOTE: The default password for CCUs and EUMs is carriage return.

You are now connected to the CCU or EUM with a Serial Port session, and you may

issue CLI commands to the device at the command prompt.

Bits per second 9600

Data bits 8

Parity None

Stop bits 1

Flow Control None