User's Manual Part 2

216 APCD-LM043-8.0 (DRAFT C)
Appendix D: INOP Commands
Table 43 EUM INOP CLI
In Table 43, commands that are noted with a √ in the right-hand column will not take effect
until you have rebooted the EUM.
radio frequency <frequency> Changes the CCU radio frequency.
•
<frequency> is the new radio
frequency, in tenths of a MHz. (For
example, 905.0 MHz is entered as
9050.) The radio frequency must be
within the range of 9050 to 9250. The
frequency may use only 0.2 MHz
increments and may use even values
only.
√
radio rf high|low|<value> Displays or sets the power of the CCU radio,
where programming the value to:
•
high will set the transmit power
output to +26 dBm,
•
low will set the transmit power to
+15 dBm, and
•
<value>, where <value>, an
integer between 15 and 26
inclusive, will set the transmit power
to
+<value> dBm.
NOTE: The CCU RF level should normally
be set to
high.
reset|reboot Reboots the CCU.
save | commit Saves configuration changes.
Command Syntax (CCU) Command Description
Command Syntax (EUM) Command Description
bcf
Displays the basic configuration file (BCF).
exit|quit Exits the current console session and
returns to the password prompt.
file copy|cp <source>
<destination>
Copies a file.
•
<source> is the name of the source
file.
•
<destination> is the name of the
destination file.
file delete <filename> Deletes a file.
•
<filename> is the name of the file you
want to delete.