User's Manual Part 2

9: Installing the EUM
APCD-LM043-8.0 (DRAFT C) 161
You can record and save this information in several ways:
• using the EUM Configuration Utility. Through the EUM Configuration Utility, you can
also upload and store the EUM’s complete configuration file.
• through the EUM command-line interface locally, using a Telnet session, through the
EUM Ethernet connection.
• through a Telnet session over the wireless link between the network and the EUM.
Record the information from the following session, and store it to a file.
60:02:04>
60:02:04> ip
IP Address: 172.16.4.2 / 22
IP Subnet : 10.5.0.0 ( 255.255.0.0 )
Gateway IP Address: 172.16.4.1
60:02:04>
60:02:04> radio
RF Power: HIGH
Radio Frequency: 9170
60:02:04>
60:02:04> rad rssi
Press any key to stop
RSSI[dBm] RX; TX; R1; R2; R3; F;Retry%; SQ; RNA; RNB
RSSI: -36 0; 0; 0; 0; 0; 0; 0; 7; 71; 71
RSSI: -36 887; 2; 0; 0; 0; 0; 0; 5; 72; 71
RSSI: -36 899; 2; 0; 0; 0; 0; 0; 8; 73; 72
RSSI: -36 899; 3; 0; 0; 0; 0; 0; 6; 73; 72
RSSI: -37 898; 2; 0; 0; 0; 0; 0; 5; 72; 72
RSSI: -37 898; 2; 0; 0; 0; 0; 0; 6; 71; 71
RSSI: -36 899; 2; 0; 0; 0; 0; 0; 5; 72; 72
You should also run the “file get” command from both the CCU and EUM to baseline the
installation.
To Run a “File Get” Throughput Test From the EUM
1. Open the EUM console, as described in Access Interface on page 221.
2. At the prompt, type
file get <ccu_ip_address>, and press Enter.
WaveRider Communications, Inc. LMS3000
Password:
60:ff:fe> file get 192.168.1.21
Enter password:
file transfer started (press 'qqq' to abort)...
bytes processed: 2097152 at 829 kbps
file transfer complete
Transfered "/tffs0/null" Okay.
60:ff:fe>
To Run a “File Get” Throughput Test From the CCU
1. Establish a Telnet connection to the CCU.
2. At the prompt, type
file get <eum_ip_address>, and press Enter.
WaveRider Communications, Inc. LMS3000
Password: