User's Manual Part 2

APCD-LM043-8.0 (DRAFT C) 213

Appendix D INOP Commands

If CCU or EUM software becomes inaccessible or corrupted, the unit will start in inoperative

mode (INOP). You can also force an EUM3003 to start in INOP mode to recover an EUM if the

IP address is not known. While in INOP mode, CCUs and EUMs use a subset of the regular

CLI commands. For instructions on putting an EUM3003 into INOP mode, refer to

EUM3003

INOP Button

on page 224. These INOP commands are described in the following tables.

NOTE: The radio is not functional while in INOP mode.

Table 42 CCU INOP

NOTE:

In Table 42, commands that are noted with a √ in the right-hand

column will not take effect until you have rebooted the CCU.

Command Syntax (CCU) Command Description

bcf

Displays the basic configuration file (BCF).

exit|quit Exits the current console session and

returns to the password prompt.

file copy | cp <source>

Copies a file.

•

<source> is the name of the source

file.

•

<destination> is the name of the

destination file.

file delete <filename> Deletes a file.

•

<filename> is the name of the file you

want to delete.

file dir | ls Lists the name, size, and cyclic redundancy

check (CRC) for each file.