User's Manual Part 2

Appendix C: Command-Line Syntax
APCD-LM043-8.0 (DRAFT C) 207
port delete <port number> Deletes a port filter.
•
<port number> is the port to be
deleted.
port flush Deletes all port filters.
radio Displays the radio attributes of the EUM.
radio analyse <samples>
<interval> <start> <stop>
Starts a spectral analysis.
•
<samples> is the number of RSSI and
noise floor samples taken at each
frequency. The default value is
200.
•
<interval> is the step size between
sample points. The default is
2
(200kHz), which is also the minimum
step size allowed. The maximum
interval is
200 (20MHz).
•
<start> is the lowest frequency
sampled, in 100’s of kHz. The default is
9000 (900.0MHz), which is also the
minimum allowed.
•
<stop> is the upper boundary on
frequencies sampled, in 100’s of kHz.
The default is
9300 (930.0MHz), which
is also the maximum allowed.
radio analyse last This command will redisplay the results of
the last spectral analysis that was
performed.
radio comment Adds a comment to both the tabular and the
graphical versions of the spectral analysis
output.
radio disable Disables the radio transmitter/receiver. The
radio is re-enabled automatically after
rebooting the unit.
NOTE: When using this command, ensure
that an Ethernet connection to the EUM is
available; otherwise, you will be unable to
re-enable the radio.
radio enable Enables the radio transmitter/receiver.
radio frequency Displays the EUM radio frequency in tenths
of a MHz; for example, 905.0 MHz is
displayed as 9050.
Command Syntax (EUM) Command Description