User's Manual Part 2

Appendix C: Command-Line Syntax
APCD-LM043-8.0 (DRAFT C) 203
time relay disable Disables SNTP relay over the radio
interface.
time relay disable boot Disables CCU time updates when the CCU
boots.
time relay disable registration Disables EUM time updates when an EUM
registers with a CCU.
time relay enable Enables SNTP relay over the radio
interface.
time relay period <seconds> Sets the time relay resynchronization
period, in seconds.
• Time period may be from 0 to 100000
seconds.
• Enter 0 to force immediate
resynchronization.
The default time relay period is 3600
seconds.
time server Manages NTP servers.
time server add
<aaa.bbb.ccc.ddd>
Adds or modifies an NTP server.
time server default Restores default NTP servers.
time server delete
<aaa.bbb.ccc.ddd>
Deletes an NTP server.
time server flush Deletes all NTP servers.
time set <time> Sets the system time (Greenwich Mean
Time).
•
<time> is formatted [dy-mon-year
hh:mm:ss] or [mm-dd-yy hh:mm:ss}.
This command overwrites the local time
obtained from the NTP server. The local
time will be updated on the next refresh from
the NTP server, unless the time client is
disabled.
time stats Displays time statistics.
watch <eum_id> Gathers link statistics for a specified EUM.
The watch command zeros the statistics
before executing.
watch Displays link statistics previously gathered
for a specific EUM. Note that the watch
command displays only the link statistics for
the EUM connected to this CCU for which
statistics were most recently gathered.
Command Syntax (CCU) Command Description