User's Manual Part 2

Appendix C: Command-Line Syntax
APCD-LM043-8.0 (DRAFT C) 199
radio meter Displays traffic statistics and polling
statistics totals for each grade of service.
radio meter <interval> Displays running average per second traffic
and polling statistics for each grade of
service.
•
<interval> in seconds is the time
over which the average is made. Press
any key to halt.
radio rf high|low|<value> Displays or sets the power of the CCU radio,
where programming the value to:
•
high will set the transmit power
output to +26 dBm,
•
low will set the transmit power to
+15 dBm, and
•
<value>, where <value>, an
integer between 15 and 26
inclusive, will set the transmit power
to
+<value> dBm.
NOTE: The CCU RF level should normally
be set to
high.
radio rssi Displays continuous RSSI readings. Press
any key to halt.
rcf Displays the contents of the route
configuration file (RCF).
reset|reboot Reboots the CCU.
route Displays the routing table of the CCU.
route add <aaa.bbb.ccc.ddd>
<eee.fff.ggg.hhh> <netmask>
Adds a static route to the routing table.
•
<aaa.bbb.ccc.ddd> is the Ethernet
IP address of the network being added
to the routing table.
•
<eee.fff.ggg.hhh> is the Ethernet
IP address of the gateway through
which the destination is reached.
•
<netmask> is the subnet mask of the
destination network
(0-32).
Command Syntax (CCU) Command Description