User's Manual Part 1

8 APCD-LM043-8.0 (DRAFT C)
2: Quick Startup
You will see the CCU command prompt:
60:03:3a>
NOTE: The default prompt on a CCU includes the last five characters of
the CCU Serial Number.
3. Type the following commands to configure the CCU (commands are shown in bold):
60:03:3a> protocol switched
CCU in Switched Ethernet Mode
60:03:3a> ip radio 192.168.10.2 24
IP Address: 192.168.10.2 / 24
IP Subnet : 192.168.10.0 ( 255.255.255.0 )
60:03:3a> ip gateway 192.168.10.1
Gateway IP Address: 192.168.10.1
60:03:3a> ra freq 9050
Radio Frequency: 9050
60:03:3a> save
Basic Config saved
Port Filter Config saved
sntp cfg file saved
Route Config saved
Authorization Database saved
DHCP Server Config saved
60:03:3a>
NOTE: The new configuration will not be stored in non-volatile memory
until you enter the save command. New IP and radio settings will
not take effect until you reset the CCU.
4. Reboot the CCU for the changes to take effect.
60:03:3a> reset
rebooting CCU ...
5. Once the CCU has finished rebooting, log back into the unit and enter the commands
shown in bold below to confirm the new IP and radio configurations:
WaveRider Communications, Inc. LMS3000
Password: ****
60:03:3a > protocol
CCU in Switched Ethernet Mode
60:03:3a > ip
IP Address: 192.168.10.2 / 24
IP Subnet : 192.168.10.0 ( 255.255.255.0 )
Gateway IP Address: 192.168.10.1
60:03:3a > radio
RF Power: HIGH
Radio Frequency: 9050
60:03:3a >