User's Manual Part 1

2: Quick Startup
APCD-LM043-8.0 (DRAFT C) 7
• Ensure the paths between the CCU and EUMs are relatively free from obstruction.
Figure 2 Quick Startup — CCU Configuration
For detailed information on connecting to CCUs and EUMs, please refer to Appendix E on
page 221.
This section explains how to configure CCU and EUM parameters using the CLI.
2.4 CCU Configuration
The CCU serves as a switch. Normal end-user traffic is switched between the CCU Ethernet
and radio interfaces.
In the following procedure, you will configure the following parameters on the CCU:
• Gateway IP address
• Radio IP address and subnet mask
• Radio frequency
To Configure the CCU
1. Open a connection to the serial console port, as described in Access Interface on
page 221.
You will see the following prompt:
WaveRider Communications, Inc. LMS3000
Password:
2. Type the password and press Enter.
NOTE: The factory default password is a carriage return.
CCU3000
RS232 cable
CCU set-up
antenna
CCU power
supply
EUM
EUM Antenna
EUM Power Supply
1
2
3
4
5
6
7
10 - 15 ft