User's Manual Part 1

xxx APCD-LM043-8.0 (DRAFT C)

Radio Meter Improvement

The radio meter command can now take an interval in seconds [1-30] as an argument and

prints the metered values in rates per second, over that interval. The printouts continue at that

interval until a key is pressed or the console times out. If no argument is given, the totals are

printed. Only GOS classes that had some activity during the interval are displayed.

Determining the Software Version on a CCU or EUM

If you are uncertain which software version you have installed on a CCU or EUM, use the

following commands to determine the version.

To Determine the Software Version on a CCU or EUM

1. Open the CCU or EUM console, as described in Access Interface on page 221.

2. At the prompt, type sys ver and press Enter.

The software version is listed under the SA1110 heading. The Hardware Rev. is “A” if

the device is a CCU3000 or EUM3000, and Hardware Rev. is “B” if the device is an

EUM3003.

60:03:3a> sys ver

SA1110

-------------------------------------------------

CPU : WaveRider LMS3000 - ARMSA1110

Hardware Rev. : A

OS-BSP Version : 5.4/1.4

Software Version: v4.0

Software Build : 9 - Polled MAC

Creation Date : Mar 24 2003

ATMEL

------------------------------------------------

Vendor : WaveRider

Firmware Version: V2(p)1.2

Hardware Rev. : V1(CCU)

Bootrom

-------------------------------------------------

VxWorks version 1.4

Bootrom release v4.0

Created Mar 24 2003, 16:25:10

60:03:3a>