User's Manual Part 1
148 APCD-LM043-8.0 (DRAFT C)
9: Installing the EUM
NOTE: The DC power cable features a secure locking connector. To
disconnect the cable, pull the collar back on the connector, then
continue pulling to detach the DC power cable from the EUM.
3. Connect the AC power cord between the AC/DC adaptor and either an AC power bar
(preferred) or AC outlet (Figure 52). The EUM immediately powers up since it does
not have an ON/OFF switch.
NOTE: To avoid potential damage to the EUM components in the event
of a power surge, WaveRider recommends using a power bar
with surge protection (instead of connecting the AC power cord
directly to an AC outlet).
Figure 52 Connect the AC Power Cord
The EUM uses a custom antenna cable and connector. If you
need to extend this cable, contact WaveRider Communications
Inc.
Power Bar
AC Power Cable
AC/DC Adaptor