User's Manual Part 1

144 APCD-LM043-8.0 (DRAFT C)
9: Installing the EUM
9.2 Other EUM Programming Considerations
Although the IP settings identified above are required for basic EUM operation, you should
also consider pre-configuring the following EUM parameters:
SNMP
SNMP communities can be configured in the EUM to enable remote monitoring of the EUM
using an SNMP manager. Refer to
Configuring SNMP on page 140.
Customer List
The factory default configuration allows only one PC to be logically connected to the EUM at
any given time. If you want to use a separate PC as an aid to installing and confirming the
EUM link prior to connecting the end-user PC, then you will have to reset the EUM when
changing between the end-user PC and the installation test PC. Refer to
Configuring the
Customer List
on page 142.
Port Filtering
Port filtering is set in the EUM to filter out Network Neighborhood. You can edit Port filtering in
the EUM, if desired. Refer to
Configuring Port Filtering on page 139.
Output Power
In most cases, the EUM output power should be set to HIGH, unless the site has unique
requirements for which a numerically set, or LOW power level, is more appropriate. For
example, you may want to numerically set the power level to a lower value in high-density
environments, where site-to-site interference is a problem.
9.3 Installation Overview
Installing the EUM involves the following procedures:
1.
Opening the Box on page 145
2.
Turning off the End-user’s Cordless Phones on page 146
3.
Choosing a Location for the EUM and Antenna on page 146
4.
Connecting the EUM Components on page 146
5.
Conducting a Preliminary Check of the EUM on page 149
6.
Positioning the Antenna on page 149
7.
Mounting the Antenna on page 151