User's Manual Part 1

APCD-LM043-8.0 (DRAFT C) 143
9 Installing the EUM
9.1 Before you Start the EUM Installation
NOTE: The following procedure assumes the end-user PC is using
DHCP.
Before you start the EUM installation, ensure the following points have been addressed:
• The EUM has been configured with at least the following settings:
• IP address
• Subnet mask
• Gateway IP address
• Radio frequency
• The CCU network is installed and verified.
• DHCP is configured, including DHCP relay at the CCU if necessary
• The end-user PC is equipped with an Ethernet interface card, and is configured to
obtain its IP address remotely, using DHCP.
• The installer knows the direction from the EUM to the CCU (CAP site).
• The installer has read this chapter.
• The installer knows the EUM IP address.
• The EUM is authorized at the CCU, or through RADIUS, possibly by setting a GOS
other than “denied” as the default GOS (or no communications will be possible).
Procedures are provided below for addressing situations where some of the above items
could not be taken care of prior to the EUM installation.