User's Manual Part 1

142 APCD-LM043-8.0 (DRAFT C)
8: Configuring the EUM
8.6 Configuring the Customer List
You can set the maximum number of customers or PCs (customer_max) that can concurrently
access the radio link through the EUM, as described in
Bridge Table (EUM or CCU in
Switched Ethernet or Through Only Mode)
on page 242.
NOTE: The simulation data presented in Performance Modelling on page
47 is based on one end user (one PC) per EUM.
TIP: When you are locally troubleshooting the EUM installation, if
customer_max is set to ‘1’ and you want to substitute and use a
known-working PC in place of the end-user’s PC, you will have to
reset the EUM or wait for the Bridge Table to time out. You will not
be able to access the EUM for 10 minutes.
To Set customer_max
1. Type cust max <value> and press Enter.
• <value> is the maximum number of customers (PCs), from 1-50.
2. Type
save or commit and press Enter.
The following example
•Sets
customer_max to 3,
• Saves the new setting, and
• Displays the value of
customer_max.
60:ff:fe>
60:ff:fe> cust max 3
Maximum customers: 3
60:ff:fe>
60:ff:fe> save
Basic Config saved
Port Filter Config saved
sntp cfg file saved
60:ff:fe>
60:ff:fe> cust max
Maximum customers: 3
60:ff:fe>