User's Manual Part 1

7: Configuring the CCU
APCD-LM043-8.0 (DRAFT C) 121
• Add an NTP server, if the one to which you want the CCU to synchronize has not
already been added. You may want to delete the default NTP servers, to force the
CCU to synchronize to the server you are adding.
• Set the SNTP client resynchronization period. The factory default setting is 3600
seconds, and WaveRider recommends not changing this default setting.
NOTE: These factory defaults are stored in the supplied sntp.cfg file.
• Enable the SNTP client, to force the CCU to synchronize to an NTP server.
• Enable the SNTP relay, if you want the EUMs to be synchronized to the CCU.
To Add an NTP Server
1. Type time server add <aaa.bbb.ccc.ddd> and press Enter.
• <aaa.bbb.ccc.ddd> is the IP address of the NTP server you are adding
.
2. Type save or commit and press Enter.
60:00:43> time server add 10.0.0.1
NTP SERVERS
-----------------------------------
132.246.168.148
140.162.8.3
136.159.2.1
192.5.5.250
10.0.0.1
-----------------------------------
60:00:43> save
Basic Config saved
Port Filter Config saved
sntp cfg file saved
Route Config saved
Authorization Database saved
DHCP Server Config saved
60:00:43>
NOTE: It is a good idea to ping the time servers from the CCU before
adding them, to ensure you have connectivity.
To Enable the SNTP Client
NOTE: Enabling the time client on the CCU causes the CCU to get the
time from the server on a regular basis.
1. Type
time client enable and press Enter.
2. Type
save or commit and press Enter.
60:00:43> time client enable
Time Client enabled
60:00:43>