User's Manual

Table Of Contents
8 Configuring the EUM
APCD-LM043-4.0 99
2. Type save or commit and press Enter.
3. Before the new power level will take effect, you must reboot the EUM by typing reset
and pressing Enter.
Example:
The following example
Sets the EUM operating frequency to 917 MHz,
Sets the transmit power level to high,
Saves the new settings,
Reboots the EUM so that they new parameters take effect, and
Displays the EUM RF parameters.
Console>
Console> radio frequency 9170
Console> radio rf high
Console>
Console> save
Basic Config saved
Port Filter Config saved
sntp cfg file saved
Console>
Console> reset
rebooting EUM ...
(... Power On Self Test ...)
WaveRider Communications, Inc. LMS3000
Password:
Console>
Console> radio
RF Power: HIGH
Radio Frequency: 9170
Console>
8.3 Configuring EUM IP Parameters
In IP Network Planning on page 53, you determined the following:
CCU radio IP address and subnet mask
EUM Ethernet IP address and subnet mask
End-user PC Ethernet IP address and subnet mask
To set the EUM Ethernet IP address
1. Type ip ethernet <aaa.bbb.ccc.ddd> <net mask> and press Enter.
<aaa.bbb.ccc.ddd> is the CCU Ethernet IP address.
<net mask> is the net mask.