User's Manual

7 Configuring the CCU
APCD-LM043-4.0 85
4. At the Verify password prompt, type the new password again.
The system displays a message that your password has been successfully changed.
Example:
Console> password
Enter Current Password: ********
Enter New Password: ********
Verify password: ********
Saving new password
Password Changed
Console>
CAUTION: Remember to record the password. Unlocking the
CCU can only be performed by contacting WaveRider Technical
Support.
7.3 Configuring the CCU RF Parameters
To set the CCU Operating Frequency
1. Type radio frequency <frequency> and press Enter.
• <frequency> is the CCU operating frequency in tenths of a MHz. For example,
917.0 MHz is entered as 9170.
2. Type save or commit and press Enter.
3. Before the new radio frequency will take effect, you must reboot the CCU by typing
reset and pressing Enter.
To set the CCU Power Level
1. Type radio rf <power level> and press Enter.
• <power level> is the CCU transmit power level, either high (+26 dBm) or
low (+15 dBm). In most cases, the CCU power level should be set to high.
NOTE: Use the HIGH power level unless your site has unique
requirements for which the LOW power level is more appropriate.
2. Type save or commit and press Enter.
3. Before the new power level will take effect, you must reboot the CCU by typing reset
and pressing Enter.
Example:
The following example
• Sets the CCU operating frequency to 917 MHz,
• Sets the transmit power level to high,