User's Manual

APCD-LM043-4.0 83
7 Configuring the CCU
This section explains the following procedures and topics:
• CCU and EUM Serial Number, MAC Address, and Station ID on page 84
• Setting the CCU Password on page 84
• Configuring the CCU RF Parameters on page 85
• Configuring CCU IP Parameters on page 86
• Configuring DHCP Relay on page 88
• Configuring Port Filtering on page 89
• Configuring the SNTP/UTC Time Clock on page 90
• Configuring SNMP on page 93
• Adding EUMs to the Authorization Table on page 95
Before you configure the CCU
• Familiarize yourself with the CLI commands, syntax and shortcuts, outlined in
Appendix C on page 163. This appendix provides a complete list of the available CCU
commands, some of which are not discussed in this section.
• Connect a PC to the CCU directly to the console port, or through a Telnet session.
See Command-line Interface on page 76 for console settings.
CAUTION: Remember to regularly enter save or commit and
press Enter, to save your configuration changes to the file system.
As well, some parameters and configuration files (refer to Table 20
on page 81 for details) do not take effect until you reboot the unit,
specifically the RF frequency, transmit power, and IP addressing.
CAUTION: After you have finished making your configuration
changes, remember to disconnect your terminal from the CCU.