User's Manual

xv APCD-LM048-1.3
7. Use only attachments recommended by WaveRider.
8. The fins and metal casing protect the EUM3006 from overheating to ensure reliable
operations. Do not cover the EUM3006 and PoE Injector. Do not place the EUM3006
or PoE Injector near or over a radiator, stove, heat register or other source of heat. Do
not place the EUM3006 and PoE Injector in a built-in installation such as a bookcase
or rack unless proper ventilation is provided. The EUM3006 has an outdoor
temperature rating, so it can handle a much larger range of temperatures than the
PoE injector. However, it is still possible to exceed the EUM3006 specifications by
improper placement or ventilation.
9. Operate the EUM3006 only from a 48 VDC PoE Mode B power source.
10. Operate the PoE Injector only from a 100 - 250 VAC, single phase, 47-63 Hz AC
power source. The PoE Injector is rated for indoor use only.
11. The PoE Injector is equipped with a 3-wire grounding-type plug, which will only fit into
a grounding-type power outlet. This is a safety feature. If you are unable to insert the
plug into the outlet, contact an electrician to replace your obsolete outlet. Do not
defeat the purpose of the grounding-type plug.
12. Route the AC Power-supply cord and Ethernet cables so that they are not likely to be
walked on or pinched by items placed upon or against them, paying particular
attention to cord and cables at their plugs, convenience receptacles and the points
where the cords exit the equipment.
13. Provide strain relief for cables near their connections. This is typically done by leaving
a loop in the cable near the connection.
14. Ensure the system is properly grounded to provide some protection against voltage
surges and built-up static charges.
15. Do not locate the EUM3006 in the vicinity of overhead power lines or other electric
light or power circuits, or where it can fall onto such power lines or circuits. When
installing outdoors, take extreme care to keep from touching such power lines or
circuits, as contact with them might be fatal.
16. For added protection during a lightning storm, or when it is left unattended and unused
for long periods of time, unplug the Ethernet cable from the PoE injector to the
EUM3006 and unplug the PoE Injector from the wall outlet. If the Ethernet cable to the
EUM3006 goes through a PoE Lightning Arrestor, then disconnect the inside Ethernet
cable. This will power down the EUM3006.
17. Do not overload wall outlets and extension cords as this increases the risk of fire or
electric shock.
18. Never push objects of any kind through openings in this wireless product as they may
touch dangerous voltage points or short-out parts that could result in a fire or electric
shock. Never spill liquid of any kind on the PoE Injector. The EUM3006 is an outdoor
unit, but it is not submersible nor is it immune to all liquids.
19. Do not attempt to service this wireless product yourself, as opening or removing
covers may expose you to dangerous voltage or other hazards. Refer all servicing to
qualified service personnel.