User Manual

TN131C 915A Radio Operational Requirements
Lawrence Gordon Page 6 of 8 Last saved on 27-Mar-06 5:45 PM
F:\Tech Notes\TN131C - 915A Radio Operational Requirements.doc
radio and any of its final products and should be included in any final product installation guide,
edited as appropriate (e.g. use final product name rather than 915A Radio).
The regulatory notices in sections 2.1.1, 2.1.2, and 2.1.3 must be included in the installation
guide for the final product edited as appropriate (e.g. use final product name rather than 915A
Radio). As well, the final product installation guide must provide NO instructions on how to
remove the 915A radio from the product. The following notices should be included to make this
clear:
This product contains no user-serviceable parts. Opening this product will void any warranty.
2.3 Final Product Labeling Requirements
The final product must have a permanent label that contains the following text:
“Contains FCC ID: OOX-915A” and
“Contains IC: 3225B-915A”.
If the label has room, then the statement “This device complies with Part 15 of FCC rules” plus
the text from the Interference Environment sub-section of 2.1.1 should be included.
The following picture shows the WaveRider standard label that is recommended for all products
containing the 915A radio, edited as appropriate.
B.1
2.4 Power Supplies
The 915A radio is approved by FCC and IC using specific AC/DC converters. The currently
approved converter is the Fairway WVG 10F-420A, AC to 4.2 VDC power supply. The use of
any other AC power supply requires testing to ensure it complies with FCC and IC rules on
Conducted Limits on AC lines (e.g. [Part 15] 15.207).