Specifications

4
02/09
Sumlog Sensor
TU00-0752-7307102
1-4
3
TU00-0752-7307102
GB
Technische Änderungen vorbehalten - Technical details subject to change
INSTALLATION INSTRUCTIONS: Viewline 85 mm
Removal of the sending unit
Loosen the union nut and pull the sending unit from the sleeve by rotating it slightly. Immediately insert the blind plug.
Never pull on the cable to remove the sending unit. Always use the loop.
Always insert the blind plug when the sending unit has been removed
The paddle wheel of the sending unit is rotated
by the flow of water. The rotational speed of the paddle
wheel is measured without contacts, and transmitted to
the indicating instrument.
Use a screwdriver to replace the paddle wheel and its
shaft.
Carefully lift the paddle wheel shaft upwards to remove it
from the sending unit.
Insert the new shaft into the new paddle wheel and install
shaft and wheel, again using the screwdriver.
Check the correct installation direction when replacing
the paddle wheel. The spoon-shaped leading surface of
the wheel (A) must be directed towards the pointed side
of the loop (S).
The pointed side of the loop must be directed to the bow
when the sending unit is inserted in the hull sleeve.
A
S
A
A
Bug
Replacement of the paddle wheel
Paddle wheel for indicating range
12 (kn, km/h, mph)
Paddle wheel for indicating range
30 and 50 (kn, km/h, mph)
3