APPN 01/10 Istruzioni di montaggio Sumlog® Viewline: adattamento al trasmettitore analogico N01-140-302 it.vdo.
VERDE MARRONE In caso di collegamento a sensori analogici (N01-140-302) è possibile utilizzare uno dei 2 cavi di prolunga N05-801-846 (10mt) o N05-801-852 (20mt) tagliando il connettore RJ45 e collegando i 3 fili Bianco-Verde-Marrone nel seguente modo: (I colori sono riferiti al cablaggio IT-0054CA) BIANCO: al filo GIALLO (pos.4) del Sumlog® Viewline VERDE: al filo VERDE (pos.5) del Sumlog® Viewline MARRONE: al filo BLU-NERO (pos.
INSTALLATION INSTRUCTIONS: Viewline 85 mm Sumlog Sensor TU00-0752-7307102 Safety information • The product was developed, manufactured and inspected according to the basic safety requirements of EC Guidelines and state-of-the-art technology. • The unit is designed for use in grounded vehicles and machines as well as in nautical sports, including non-classified commercial shipping. • Use our product only as intended.
INSTALLATION INSTRUCTIONS: Viewline 85 mm Sumlog Sensor 1 TU00-0752-7307102 02/09 GB 1-4 2 Installation of the sending unit The sending unit must be installed in a turbulence-free zone in the hull. If an echo sounder is installed, the Sumlog sending unit should be installed at the same height and to the side of, or laterally offset to the echosounder. Check for sufficient distance to stanchions, stringers, bulkheads, etc. when drilling the hull.
INSTALLATION INSTRUCTIONS: Viewline 85 mm Sumlog Sensor 3 TU00-0752-7307102 02/09 GB 1-4 3 Removal of the sending unit Loosen the union nut and pull the sending unit from the sleeve by rotating it slightly. Immediately insert the blind plug. Never pull on the cable to remove the sending unit. Always use the loop. Always insert the blind plug when the sending unit has been removed 4 Replacement of the paddle wheel The paddle wheel of the sending unit is rotated by the flow of water.
INSTALLATION INSTRUCTIONS: Viewline 85 mm Sumlog Sensor Connection to Viewline Sumlog ✄ 5 TU00-0752-7307102 white green brown 02/09 GB 1-4 4 +12V Sensor minus Remove the plug Strip the individual lead 5 Calibration After installation of the system your Viewline Sumlog must be calibrated to obtain speed and distance measurements with the maximum accuracy. On the Viewline Sumlog display, select the setting for the die function.
