Technical information

146
Visibility
508_en_Chap05_visibilite_ed02-2014
Manual adjustment
of halogen
headlamps
Automatic adjustment of "full LED"
technology headlamps
To avoid causing a nuisance to other road
users, the beams of the halogen headlamps
should be adjusted according to the load in the
vehicle.
0 Driver or driver + front passenger.
- Driver + front passenger + rear
passengers.
1 5 people.
- 5 people + a load in the boot.
2 Driver + a load in the boot.
If a fault occurs, this
warning lamp is displayed
in the instrument panel,
accompanied by an audible signal and a
message in the instrument panel screen.
The system then places your headlamps in the
lowest position.
In order to avoid causing a nuisance to other
road users, this system corrects the height of
the "full LED" headlamps beam automatically,
in relation to the load in the vehicle.
If a fault occurs, do not touch the "full
LED" bulbs. Contact a PEUGEOT
dealer or a qualified workshop.
The initial setting is position "0".
Travelling abroad
The design of the dipped beam
headlamps allows, without modification,
driving in a country that drives on the
other side of the road to the country in
which your vehicle was sold.