Technical data

Obsolete and Discontinued Commands 33

Keysight InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 735

:MEASure:VSTOp

(see page 792)

Command Syntax

:MEASure:VSTOp <vstop_argument>

<vstop_argument> ::= value for Y2 cursor

The :MEASure:VSTOp command moves the vertical marker 2 (Y2 cursor) to the

specified value corresponding to the selected source. The source can be selected

by the MARKer:X2Y2source command.

Query Syntax

:MEASure:VSTOp?

The :MEASure:VSTOp? query returns the current value of the Y2 cursor.

Return Format

<value> ::= value of the Y2 cursor in NR3 format

See Also • "Introduction to :MARKer Commands" on page 318

• "Introduction to :MEASure Commands" on page 340

• ":MARKer:Y1Position" on page 327

• ":MARKer:Y2Position" on page 328

• ":MARKer:YDELta" on page 329

• ":MARKer:X2Y2source" on page 323

• ":MEASure:SOURce" on page 361

• ":MEASure:TDELta" on page 727

• ":MEASure:TSTArt" on page 729

NOTE

The short form of this command, VSTO, does not follow the defined Long Form to Short Form

Truncation Rules (see page 794). The normal short form, VST, would be the same for both

VSTArt and VSTOp, so sending VST for the VSTOp command produces an error.

NOTE

The :MEASure:VSTOp command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:Y2Position command (see page 328) instead.