Technical data

Obsolete and Discontinued Commands 33

Keysight InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 733

:MEASure:VDELta

(see page 792)

Query Syntax

:MEASure:VDELta?

The :MEASure:VDELta? query returns the voltage difference between vertical

marker 1 (Y1 cursor) and vertical marker 2 (Y2 cursor). No measurement is made

when the :MEASure:VDELta? query is received by the oscilloscope. The delta value

that is returned is the current value. This is the same value as the front-panel

cursors delta Y value.

VDELta = value at marker 2 - value at marker 1

Return Format

<value> ::= delta V value in NR1 format

See Also • "Introduction to :MARKer Commands" on page 318

• "Introduction to :MEASure Commands" on page 340

• ":MARKer:Y1Position" on page 327

• ":MARKer:Y2Position" on page 328

• ":MARKer:YDELta" on page 329

• ":MEASure:TDELta" on page 727

• ":MEASure:TSTArt" on page 729

NOTE

The :MEASure:VDELta command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:YDELta command (see page 329) instead.