Technical data

706 Keysight InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
33 Obsolete and Discontinued Commands
Discontinued
Commands
Discontinued commands are commands that were used by previous oscilloscopes,
but are not supported by the InfiniiVision 2000 X-Series oscilloscopes. Listed
below are the Discontinued commands and the nearest equivalent command
available (if any).
:PRINt? (see page 744):DISPlay:DATA? (see
page 258)
:SAVE:IMAGe:AREA (see
page 746)
none
:TIMebase:DELay (see
page 747)
:TIMebase:POSition (see
page 580) or
:TIMebase:WINDow:POSition
(see page 585)
TIMebase:POSition is position
value of main time base;
TIMebase:WINDow:POSition is
position value of zoomed
(delayed) time base window.
:TRIGger:THReshold (see
page 748)
:POD<n>:THReshold (see
page 415) or
:DIGital<d>:THReshold (see
page 249)
:TRIGger:TV:TVMode (see
page 749)
:TRIGger:TV:MODE (see
page 623)
Obsolete Command Current Command Equivalent Behavior Differences
Discontinued Command Current Command Equivalent Comments
ASTore :DISPlay:PERSistence INFinite
(see page 261)
CHANnel:MATH :FUNCtion:OPERation (see
page 289)
ADD not included
CHANnel<n>:PROTect :CHANnel<n>:PROTection (see
page 232)
Previous form of this command
was used to enable/disable
50Ω protection. The new
command resets a tripped
protect and the query returns
the status of TRIPed or
NORMal.
DISPlay:INVerse none
DISPlay:COLumn none
DISPlay:FREeze none
DISPlay:GRID none
DISPLay:LINE none
DISPlay:PIXel none