Technical data

:SBUS<n> Commands 25
Keysight InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 529
:SBUS<n>:UART:TRIGger:TYPE
(see page 792)
Command Syntax
:SBUS<n>:UART:TRIGger:TYPE <value>
<value> ::= {RSTArt | RSTOp | RDATa | RD1 | RD0 | RDX | PARityerror
| TSTArt | TSTOp | TDATa | TD1 | TD0 | TDX}
The :SBUS<n>:UART:TRIGger:TYPE command selects the UART trigger type.
When one of the RD or TD types is selected, the :SBUS<n>:UART:TRIGger:DATA
and :SBUS<n>:UART:TRIGger:QUALifier commands are used to specify the data
value and comparison operator.
The RD1, RD0, RDX, TD1, TD0, and TDX types (for triggering on data and alert bit
values) are only valid when a 9-bit width has been selected.
Query Syntax
:SBUS<n>:UART:TRIGger:TYPE?
The :SBUS<n>:UART:TRIGger:TYPE? query returns the current UART trigger data
value.
Return Format
<value><NL>
<value> ::= {RSTA | RSTO | RDAT | RD1 | RD0 | RDX | PAR | TSTA |
TSTO | TDAT | TD1 | TD0 | TDX}
See Also • "Introduction to :TRIGger Commands" on page 589
• ":TRIGger:MODE" on page 598
• ":SBUS<n>:UART:TRIGger:DATA" on page 526
• ":SBUS<n>:UART:TRIGger:QUALifier" on page 528
• ":SBUS<n>:UART:WIDTh" on page 530